Expedition 4WD V8-5.4L VIN 5 (2006)
Ignition Lock: Service and Repair
Ignition Lock Cylinder - Non Functional
IGNITION LOCK CYLINDER - NON FUNCTIONAL
Removal and Installation
1. Remove the passive anti-theft system (PATS) transceiver.
2. Remove the ignition lock cylinder.
-
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
-
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition lock cylinder breaks loose.
-
Remove and discard the ignition lock cylinder and drill shavings from the steering column.
3. Remove the bearing retainer.
4. Remove the steering column lock housing bearing and steering column lock gear.
-
Thoroughly clean all drill shavings from the steering column and inspect it for damage.
5. NOTE: Use a new ignition lock cylinder.
To install, reverse the removal procedure.
-
Verify ignition switch lock cylinder operation.
