Expedition 4WD V8-5.4L VIN 5 (2006)
^
To install, tighten to 150 Nm (111 ft. lbs.).
6. Remove the upper arm rearward nut, bolt and the upper arm.
^
Discard the nut.
^
To install, tighten to 250 Nm (184 ft. lbs.).
7. CAUTION: Do not tighten the upper arm forward and rearward nuts and bolts until the installation procedure is complete and the weight of the
vehicle is resting on the wheel and tire assemblies.
To install, reverse the removal procedure.
8. Check and, if necessary, adjust the rear alignment.
Lower Arm
Lower Arm
