Explorer 2WD V6-245 4.0L (1994)
3.
Measure from the inner sill on panel outward 1-13/16" (46 mm), Figure 1.
4.
Measure from bottom of sill up 3/16" (4.76 mm).
5.
With a 1/2" (12.7 mm) center aligned Blair cutter (Matco S3K 1/2 cutter, Matco C217X Arbor) cut a hole for access to pull handle retaining
screw. See Figure 1.
NOTE:
TO ENSURE ADEQUATE CLEARANCE FOR SCREW REMOVAL, TILT THE CUTTER AT A SLIGHT DOWNWARD ANGLE AND
MAINTAIN THE 3/16" (4.76 mm) DIMENSION FOR CENTER OF HOLE.
6.
Remove screw to pull handle.