Explorer 2WD V6-245 4.0L (1994)
25.
Center punch the center point between the two upper spot welds on the lower lift cylinder bracket. See Figure 9. This point should be
approximately 20 mm (3/4 inch) from the top of the bracket and centered horizontally.
26.
Drill a 5 mm (3/16-inch) hole at the center-punched location. Install a rivet.
27.
Repeat this procedure for opposite side lift cylinder bracket.
28.
Connect the lift cylinders to the upper lift cylinder brackets.
29.
Remove the jack stand.
30.
Verify liftgate operation.