Explorer 2WD V6-245 4.0L (1994)
Wheel Cylinder: Testing and Inspection
WARNING: Brake assembly dust and dirt should not be removed by either blowing off with an air gun or vacuuming with a standard
industrial vacuum cleaner because a health hazard from breathing in asbestos dust may develop. Also, any machining done on brake linings or
pads should be done using proper exhaust-ventilated equipment.
NOTE: Removal of dust and dirt from brake assemblies should be done by using the Rotunda Brake and Clutch Service Vacuum 091-00001 or Rotunda
Brake Parts Washer 065-00016 or an equivalent.
INSPECTION
1. Rear wheel cylinders should not be disassembled unless they are leaking. Pull back each rear wheel cylinder dust boot and inspect for leakage.
2. Excessive brake fluid at this point indicates leakage past the piston cups and a need for rear wheel cylinder (2261) overhaul. A slight amount of
fluid is nearly always present and acts as a lubricant for the pistons. If evidence of leakage is noted, the rear wheel cylinder should be
disassembled, inspected and overhauled.
3. Inspect the rear wheel cylinder bore for scratches and pitting. If the rear wheel cylinder is pitted or has deep scratches, the rear wheel cylinder must
be replaced.
