Explorer 2WD V6-245 4.0L (1994)
Aligning Timing Marks
4. Turn the camshaft and crankshaft as necessary to align the timing marks. Install the camshaft sprocket, install the attaching bolt and tighten to
60-68 N.m (44-50 lb-ft).
5. Check the camshaft for correct end play. End play should be 0.065-0.165mm (0.025-0.064 inch). Remove the clip from the timing chain tensioner
.
6. Position the valve tappets in their original locations. Apply SAE 50 Service SG or equivalent oil meeting Ford specification ESE-M2C39-F to
both ends of the push rods. Install the push rods in the same locations as removed.
7. Install the intake manifolds.
8. Install the rocker arm shaft assemblies. Tighten the rocker arm stand bolts evenly and in sequence to 6-8 N.m (53-71 lb-in).
9. Install the valve covers.
10. Install the engine front cover as an assembly.
Installing Oil Pump Drive
11. Install the oil pump drive, hold-down clamp and screw.
