Explorer 2WD V6-245 4.0L (1994)
Engine Wiring Harness
7. Remove wiring harness from valve cover and position out of the way using door trim panel remover tool.
8. Remove spark plug wires from the spark plugs and clips on valve cover.
Engine Wiring Harness
9. Remove engine wiring harness clip from valve cover-to-intake manifold stud. Do not pull on harness. Lift up on clip with your thumb.
10. Remove retaining bolt from fuel hose clip to front of engine to allow fuel hoses to be moved enough to gain access to upper front valve cover bolt.
Valve Cover Reinforcement Plate Removal
11. Remove bolts, reinforcement plates, and the valve cover.
INSTALLATION
1. Clean valve cover, cylinder head, and intake manifold gasket surfaces.
