Explorer 2WD V6-245 4.0L (1994)
Idle Air Control (IAC) Valve: Removal and Replacement
Idle Air Control Valve
REMOVAL
1. Disconnect the Idle Air Control (IAC) valve connector from the fuel charging wiring.
2. Remove the two IAC valve retaining bolts.
3. Remove the IAC valve and IAC gasket.
NOTE: If scraping is necessary, be careful not to damage IAC valve, throttle body gasket surfaces or drop material into throttle body.
INSTALLATION
1. Make sure that both throttle body and valve gasket surfaces are clean.
2. Install IAC gasket on throttle body surface and mount IAC valve, securing it with two retaining screws. Tighten to 9-11 Nm (80-97 in lb).