Explorer 2WD V6-245 4.0L (1994)
Ignition Coil: Service and Repair
Coil Pack Assembly
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector from the coil pack.
3. Remove the spark plug wires by squeezing the locking tabs to release the coil boot retainers.
4. If vehicle is equipped with air conditioning, remove the air conditioning tube to plenum bolt and move the tube enough to gain access to the upper
coil pack bolts.
5. Remove the coil pack mounting screws and remove the coil pack.
INSTALLATION
1. Install the coil pack and mounting screws.
2. Tighten to 44-62 lb. in. (5-7 N-m).
3. If vehicle is equipped with air conditioning, reposition the air conditioning tube and replace the bolt.
4. Connect the spark plug wires and electrical connector to the coil pack.
5. Connect the negative battery cable.
NOTE: When the battery has been disconnected, some abnormal drive symptoms may occur while the powertrain control module relearns its
adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.