Explorer 2WD V6-245 4.0L (1994)
1. Mount the valve hosing in the bench mounted holding fixture, Tool T57L-5O0-B, with the flanged end up.
2. Apply a light coat of Premium Power Steering Fluid, E6AZ-19582-AA (ESW-M2C33-F) or equivalent to the Teflon rings on the valve sleeve.
3. Carefully install the worm shaft and valve in the housing.
4. Install the worm bearing race nut in the housing and tighten to 75 - 122 N.m (55 - 90 ft. lbs.).
5. Install the Allen head race nut set screw through the valve housing and tighten to specification 1.7 - 2.8 N.m (15 - 25 in. lbs.).
Fig. 3 Installing Piston On Worm Shaft
6. Place the power cylinder piston on the bench with the bell guide holes facing up. Insert the worm shaft into the piston so that the first groove is in
