Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
2.
On vehicles without a fuel delivery module, remove the negative and positive connectors from the fuel pump, Figure 1.
a.
Cut the wires to the fuel pump 76 mm (3") from the flange of the fuel pump and discard the wires.
b.
Connect the RFI filter connectors to the spade terminal on the fuel pump.
c.
Cut and solder both the red and black wires of the RFI filter to the red and black wires of the flange. Use Heat Shrink Tubing
(F5AZ-14A099-M) over the solder connections.
NOTE
HEAT SHRINK TUBING MUST BE USED OVER ALL SOLDERED CONNECTIONS MADE PRIOR TO THIS TSB. USE SUFFICIENT