Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
2. Remove the disc brake anti-rattle clips.
INSTALLATION:
-
Install the brake shoes and linings.
1. Install the disc brake anti-rattle clips.
2. Install the brake shoes and linings.
-
Install the front disc brake caliper.
1. Install the front disc brake caliper.
2. Install the front disc brake caliper slider pins.
-
Clean the wheel hub mounting surface.
WARNING: ALWAYS REMOVE ANY CORROSION, DIRT OR FOREIGN MATERIAL PRESENT ON THE MOUNTING
SURFACES OF THE WHEEL OR THE SURFACE OF THE WHEEL HUB, BRAKE DRUM OR FRONT DISC BRAKE ROTOR
THAT CONTACTS THE WHEEL. INSTALLING WHEELS WITHOUT PROPER METAL TO METAL CONTACT AT THE WHEEL
MOUNTING SURFACES CAN CAUSE THE LUG NUTS TO LOOSEN AND COULD ALLOW THE WHEEL TO COME OFF
WHILE THE VEHICLE IS IN MOTION, CAUSING LOSS OF CONTROL.
Installing Wheel And Tire Assembly
-
Install the wheel and tire assembly.
NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
1. Install the wheel and tire assembly.
