Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
EGR Electronic Vacuum Regulator Solenoid: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect the battery ground cable.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 6 km (10 mi) or more to relearn the strategy.
2. Disconnect the (A) electrical connector and the (B) vacuum hoses from the Exhaust Gas Recirculation (EGR) vacuum regulator solenoid.
3. Remove the (A) nuts and remove the (B) EGR vacuum regulator solenoid.
4. To install, reverse removal procedures.
5. Connect the battery ground cable.
