Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
4. Install the attachment parts. Original parts are to be replaced with the repair parts indicated in the manufacturer's safety belt replacement
guidelines. Unless otherwise specified, use original parts.
Seat Belt Without Anchor Plate Thread Damage
1. Expose the suspect anchor point.
NOTE: This procedure is for replacement of the weld nut. If the reinforcement is also missing, the body side must be removed and replaced.
2. Drill out two 8 mm (5/16 in) diameter access holes adjacent to the weld nut clearance hole.
3. Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
4. Use MIG Wire Feed Welder and plug weld a 7/16 inch weld nut and standard washer in place at the two 8 mm (5/16 in) holes.
5. Metal finish as required.
6. Perform a certification test.