Hazard Warning Switch: Testing and Inspection - Explorer 2WD V6-245 40L SOHC VIN E EFI (1997)
Hazard Warning Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
(1) Insert the ignition key into the ignition switch lock cylinder and turn to RUN position.
(2) Push the (A) ignition switch loci; cylinder release tab with a punch while pulling out the (B) ignition switch lock cylinder.
NOTE: Steering wheel removed for clarity.
3. If equipped, twist the tilt wheel handle and sham; counterclockwise and remove.
NOTE: Steering wheel removed for clarity.
