Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
5. Pull the MAF sensor assembly from the engine air cleaner cover and disconnect the MAF sensor electrical connector.
CAUTION: The MAF sensor electronics module and body are calibrated as a unit and must be replaced as a unit. Do not tamper with the sensing
elements located in the air flow bypass of the MAF body.
6. Remove the MAF sensor nuts and the MAF sensor.
CAUTION: The MAF sensor extension wire grommet must he fully installed and the air cleaner outlet tube must be securely fastened to prevent
unmetered air from entering the engine.
NOTE: Use the alignment notch to properly align the engine air cleaner intake and engine air cleaner cover.
7. To install, reverse the removal procedure.
8. Connect battery ground cable.