Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
2. Seat new lug bolts in axle flange.
-
Place four flat washers over the outside end of the lug bolt.
-
Thread a standard lug nut with the flat side against the washers.
-
Tighten the lug nut until the lug bolt head seats against the back side of the flange.
3. Remove the lug nut and flatwashers.
4. Install the rear disc brake rotor, rear disc support bracket and the rear disc brake caliper, if so equipped.
5. Install the wheel and tire assembly.
6. Lower the vehicle.
7. Turn the air suspension service switch on, if so equipped.