Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
2. Install the low/reverse band servo piston and rod into the servo bore along with a low/reverse servo return spring.
NOTE: An A4LD Low/Reverse Servo Return Spring D4ZZ-7D031-A is to be used only as a test spring.
3. Install Servo Rod Selecting Gauge.
(1) Install a new low/reverse servo separator plate cover gasket.
(2) Tighten the three screws.
4. Tighten the servo gauge adjusting screw.
5. Install Dial Indicator with Bracketry on the transmission case.
(1) Position the indicator on the piston pad.
(2) Set the dial indicator to zero.