Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Fluid - A/T: Service and Repair
Major Service/Overhaul
CAUTION: Use only MERCON V XT-5-QM transmission fluid. Use of any other fluids may result in a transmission malfunction or failure.
1. Loosen, then remove, the transmission fluid pan attaching bolts to drain fluid.
2. Remove and discard old pan gasket.
3. Perform required internal repair and cleaning as required.
4. Thoroughly flush torque converter, cooler lines and transmission in-tank radiator cooler and auxiliary cooler (if equipped).
5. Replace fluid filter and seal assembly.
6. Install cleaned pan and new pan gasket with screws. Tighten screws to 13-15 Nm (115-133 inch lbs.).
7. Add 3.7 liters (4 quarts) of MERCON V XT-5-QM or equivalent MERCON approved fluid to the transmission through the fill tube.
8. Start engine. Move the transmission range selector lever through all gear ranges, checking for engagements.
9. Check and adjust the transmission fluid level in 0.25 liter (1/2 pint) increments to the proper level (cross-hatched area of the fluid level indicator
at normal operating temperature).