Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Wiper Motor: Testing and Inspection
CAUTION: Do not handle the wiper motor abusively when diagnosing the wiper operations. Failure to follow this caution may result in damage to the
motor magnets and will make the wiper motor inoperative. Rough handling of new replacement wiper motors may also damage the motor magnets.
Use Alternator, Regulator, Battery and Starter Tester (ARBST) 010-00725 or equivalent to test the wiper motor on the vehicle.
To test the wiper motor, disconnect the windshield wiper mounting arm and pivot shaft from the windshield wiper motor.
Disconnect wiper motor C145. Connect the (A) green lead from (B) Alternator, Regulator, Battery and Starter Tester (ARBST) or equivalent to the
battery negative (-) post. Connect the (C) red lead from the tester to the wiper motor (D) common brush terminal (terminal 3).
Test the low speed mode by connecting a (E) cable from the battery positive (+) post to the (F) low speed brush terminal (terminal 4) and measure the
current draw. If the current draw is greater than 3.5 amperes, replace the windshield wiper motor.
Test the high speed mode by connecting a cable from the battery positive (+) post to the (G) high speed brush terminal (terminal 5) and measure the
current draw. If the current draw is greater than 5.5 amperes, replace the wiper motor.