Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
-
Airbag simulators (restraint system diagnostic tools) MUST be installed under the seats in the side airbag to floor connector.
-
Diagnostics or repairs are not to be performed on a side airbag system with the seat in the vehicle. Prior to attempting to diagnose/repair the side
airbag system the seat must be removed from the vehicle and the restraint system diagnostic tool must be installed in side airbag connector at the
floor connector. The restraint system diagnostic tool must be removed prior to operating the vehicle.
-
Diagnostics may be performed on seat systems other than the side airbag system (lumbar, climate controlled, heated, power seat track) with the
seat installed in the vehicle as long as the restraint system diagnostic tool is installed under the seat in the side airbag to floor connector.
-
After diagnosing/repairing a seat system the restraint system diagnostic tool must be removed before operating the vehicle.
-
Before disconnecting the battery, raise the seat to the highest position, then move and tilt the seat to its most forward position.
1. Deactivate the supplemental restraint system. For additional information, refer to Air Bag Systems.
2. Disassemble the seat. For additional information, refer to Seat-Front Bucket, Limited.
NOTE: Be sure to read and follow all air bag warnings in Seat-Front Bucket, Limited, Disassembly and Assembly.
3. Disconnect the seat backrest recliner actuator.
1
Remove the screws.
2
Disconnect the seat backrest recliner actuator.
4. If equipped, disconnect the seat cushion heating element electrical connector.
5. Remove the seat cushion frame from the seat cushion foam.
1
Unhook the seat cushion trim cover J-clips.
2
Remove the seat cushion frame from the seat cushion foam.
6. Invert the seat cushion trim cover.
