Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
9. If equipped, disconnect the heated seat switch electrical connector.
10. Remove the front seat cushion side shield.
11. Remove the 6-way power seat switch.
1
Remove the screws.
2
Remove the 6-way power seat switch.
INSTALLATION
1. To install, reverse the removal procedure.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
2. Reactivate the supplemental restraint system. For additional information, refer to Air Bag Systems.
3. Prove out the air bag system. For additional information, refer to Air Bag Systems.
4. Check the restraint system for proper operation.
