Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
6. Remove the canister vent solenoid and the evaporative emission tube.
1
Disconnect the canister vent solenoid hose from the canister vent solenoid.
2
Remove the canister vent solenoid.
3
Remove the evaporative emission canister purge sleeve.
4
Remove the evaporative emission tube.
7. Remove the evaporative emission canister from the evaporative emission canister bracket.
INSTALLATION
1. To install, reverse removal procedure.
^
Leak test the evaporative emissions system. For additional information, refer to Evaporative Emission System Leak Test. See: Testing and
Inspection/Component Tests and General Diagnostics/Component Tests/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair
Verification Drive Cycle. See: Service and Repair
NOTE: Lubricate all O-ring seals with MERPOL(R) O-ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.