Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
Fuel Injector Wiring Harness: Service and Repair
REMOVAL
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Remove the upper and lower intake manifolds. For additional information, refer to Engine.
3. Disconnect the three (LH) fuel injector electrical connectors.
NOTE: One connector is shown, the other two are similar.
4. Disconnect the (RH) fuel injector electrical connector.
5. Disconnect the engine bulkhead electrical connector.
6. Disconnect the Powertrain Control Module (PCM) electrical connector.
7. Disconnect the Heated Oxygen Sensor (HO2S) connectors.