Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
CAUTION: The servo must be installed prior to band adjustment.
Note: The wrench will click at the specified torque. Install new locknut, do not tighten at this time.
Tighten front band adjustment screw using the Band Adjuster Wrench Kit and back off front band adjustment screw exactly two (2) turns and hold
that position.
6. Tighten the front band locknut.
1. Hold the front band adjustment screw stationary.
2. Tighten the front band locknut.
7. Install the shift cable.
1. Install the shift cable.
2. Install the shift cable to the manual control lever.
8. Lower the vehicle.
