Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
14. Remove the Valve Body Aligner from the main control valve body.
1. Remove the Valve Body Aligner (0.248).
2. Remove the Valve Body Aligner (0.235).
15. Rotate the main control valve body so the valve body separator plate is facing down.
16. CAUTION: All solenoid electrical connectors must face upward on installation.
Note: All shift solenoids are interchangeable.
Note: If the TCC valve came out during disassembly, use caution when installing the torque converter clutch solenoid.
Install the SSB, SSD, TCC and EPC solenoids.
1. Install the TCC solenoid.
2. Install the SUB and SSD solenoids.
3. Install the EPC solenoid.
17. CAUTION: The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
Install the solenoid clamp and the screw.
1. Position the solenoid clamp on the main control valve body.
2. Install the screw.