Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
2. Tighten the special tool to scat the pinion bearing cups in their bores.
Using 205-153 and 205-DOS5
3. Using the special tools, drive the outer pinion bearing cup into the axle housing.
4. Using the special tools, drive the inner pinion bearing cup into the axle housing.
Setting pinion depth
5. CAUTION: Always install new pinion bearings when installing new bearing cups.
Note: If the feeler gauge can fit between a cup and the bottom of its bore at any point around the cup, remove and reseat the cup.
Check that the cups have seated correctly in their bores.
