Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
Align the pinion flange with the drive pinion shaft.
20. Using the special tools, install the pinion flange.
21. CAUTION: Do not under any circumstance loosen the pinion nut to reduce preload. If it is necessary to reduce preload, install a new collapsible
spacer and pinion nut.
CAUTION: Remove the special tool when taking preload readings with the Nm (inch-pound) torque wrench.
Use the special tool to hold the pinion flange while tightening the pinion nut.
-
Rotate the pinion occasionally to make sure the cone and roller bearings are seating correctly.
-
Install a Nm (inch-pound) torque wrench on the pinion nut.
-
Rotating the pinion through several revolutions, take frequent cone and roller bearing torque preload readings until the original recorded
preload reading is obtained.
-
If the original recorded preload is lower than specifications, tighten to the appropriate specifications for used bearings. If the preload is higher
than specification, tighten the nut to the original reading as recorded. Refer to the torque specification for new pinion bearings.
22. Install differential case and the remaining components.
