Explorer 2WD V6-245 4.0L SOHC VIN K SFI (2001)
NOTE: Lubricate the urethane sealant with water to aid the special tool when cutting.
12. Using the special tool, distance the windshield from the body.
13. Using the special tool, cut the remaining urethane sealant and remove the windshield glass.
14. Using a soft brush or vacuum, remove any foreign material or dirt from the pinch weld.
INSTALLATION
CAUTION: After installing the urethane installed glass, the vehicle should not be driven until the urethane has cured. The curing times at temperatures
above 13°C (55°F) and relative humidity above 50% is 12 - 24 hours (decreasing at higher temperatures and lower humidities). Inadequate curing of
the urethane may adversely affect the strength of the urethane bond.
1. Dry fit the windshield. Make alignment marks with tape or non-staining grease pencil.
2. Trim the remaining urethane sealant on the pinch weld to within the specification.
^
The existing urethane sealant surface should be smooth and free of cuts and contamination.
CAUTION: Do not scratch the pinch weld area.
3. Use a wool applicator to apply Urethane Metal Primer Essex U-413 meeting Ford specification WSB-M2G234-C to any exposed metal on the
pinch weld. Allow six to ten minutes to dry.
