Explorer 2WD V6-245 4.0L VIN X SFI (1999)
7. Use Brake Adjusting Gauge to set the rear brake shoe and lining diameter to 0.5 mm (0.020 inch) less than the inside diameter of the drum portion
of the rear brake disc.
8. Install the rear brake disc.
9. WARNING: Always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel or the surface of the
wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without correct metal to metal contact at the wheel
mounting surfaces can cause the lug nuts to loosen and come off while the vehicle is in motion, causing loss of control.
Clean the wheel hub mounting surface.
10. NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
Install the wheel and tire assembly.