Explorer 2WD V6-245 4.0L VIN X SFI (1999)
3. Remove the two screws.
4. Reaching one hand into the glove box opening, push out on the passenger air bag module and separate it from the instrument panel.
CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door.
5. Disconnect the electrical connector and remove the passenger air bag module.
INSTALLATION
NOTE: A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
1. Follow the removal procedure in reverse order.
2. Prove out the air bag system.
