Explorer 2WD V6-245 4.0L VIN X SFI (1999)
Safety Belt Bolt Bit
Special Tool(s)
REMOVAL
WARNING: All seat belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or improper operation is noted.
1. Fold the rear seat down to load floor position.
2. Remove the rear seat belt buckle and retractor assembly.
1
Use Safety Belt Bolt Bit to remove the bolt.
2
Remove the rear seat belt buckle and retractor assembly.
INSTALLATION
1. To install, reverse the removal procedure.
-
Check the restraint system for proper operation.
NOTE: Make sure the seat belt webbing is not twisted prior to installation.