Explorer 2WD V6-245 4.0L VIN X SFI (1999)
14. Remove the bearing caps and bolts.
-
To establish differential bearing preload, increase both left and right shim sizes by the specification shown in the illustration.
-
Use the Shim Driver to make sure that the differential bearing shims are fully seated and the assembly turns freely.
15. Install the bearing caps and bearing cap bolts.
16. Use the Dial Indicator with Bracketry to recheck the backlash.
17. Install the axle shafts.
18. Install the differential housing cover and refill the rear axle with specified lubricant.
