Explorer 2WD V6-4.0L (2009)
Cross-Member: Service and Repair
Transmission Support Crossmember
Transmission Support Crossmember
Transmission Support Crossmember
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 transfer case skid plate bolts and remove the transfer case skid plate.
-
To install, tighten to 15 Nm (133 lb-in).
3. NOTE: Explorer/Mountaineer shown, Explorer Sport Trac similar.
Remove the heat shield bolt from the RH heat shield.