Explorer 2WD V6-4.0L (2009)
SSE
1. Install SSE.
2. Position the solenoid bracket in place and install the 8 bolts.
-
Tighten to 6 Nm (53 lb-in).
3. Position the TCM on the mechatronic assembly.
1. TCM
2. Mechatronic assembly
4. Install the 6 long bolts into the TCM unit. Tighten the bolts in the sequence shown.
-
Tighten to 6 Nm (53 lb-in).
Mechatronic assembly
5. NOTE: Before installing the mechatronic assembly into the transmission case, verify presence and correct orientation of the thermal bypass valve,
pump adapter seal and center support seals. Also note that one or more of the center support seals may have remained in the mechatronic assembly
during removal and should be installed into the transmission case at this time.
Verify the 4 rubber feed tubes for the center support are in place.
1. Black feed tubes
2. Green feed tube
3. Blue feed tube