Explorer 2WD V6-4.0L VIN E (2001)
4. Apply (A) Foam Butyl meeting Ford specification WSB-M2G234-C to the (B) pinch weld.
5. If reinstalling original windshield, remove the excess urethane sealant from the windshield glass.
6. Clean the inside of the glass surface with an alcohol-free cleaner making sure the ceramic coated area is clean.
7. Apply Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M2G314-B twice around the glass surface to be urethaned.
NOTE: Wipe off the Glass Prep immediately after each application because it flash dries.
8. Apply Glass Primer Essex U-402 meeting Ford specification WSB-M5B280-C to the same area that was prepped in the pervious step. Allow five
minutes to dry.
9. Cut the urethane applicator tip to specification.
10. Apply a bead of urethane sealant Essex 400-HV or Essex U-216, which meets Ford specification WSB-M2G316-B to the pinch weld just outside
the foam dam.
CAUTION: If the vehicle is to be driven within 24 hours of urethane application, urethane sealant Essex U-216 must be used due to its one hour
cure time.