Explorer 2WD V6-4.0L VIN K (2007)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair
2. Remove the fan shroud.
3. Remove the accessory drive belt.
4. NOTE: This bolt is torque-to-yield and cannot be reused.
Using the special tool to hold the crankshaft pulley, remove the bolt.
5. NOTE: If the pulley bolt is not installed, the tool will bottom out before the pulley is off.
Install the crankshaft pulley bolt 2 to 3 turns. Using the special tools and the two 8-mm bolts, remove the crankshaft pulley.
^
Discard the crankshaft pulley bolt.