Explorer 2WD V6-4.0L VIN K (2007)
1. Remove the 4 front J-nuts and install new.
2. Remove the 5 rear J-nuts and install new.
3. Position safety canopy module by moving it rearward installing the rear bracket hook in the sheet metal.
4. Install the safety canopy module B-pillar bracket hook in the sheet metal.
5. NOTE: Make sure all safety canopy module bolt holes line up with all J-clips.
Install the safety canopy module front 2 bolts with the forward most bolt first.
-
Tighten to 8 Nm (71 lb-in).
6. Install the safety canopy module B-pillar bolt.
-
Tighten to 8 Nm (71 lb-in).
