Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
5. Remove the nut and disconnect the compressor manifold and tube assembly from the suction accumulator.
-
Discard the O-ring seal.
6. Raise the vehicle.
7. Remove the nuts and the brackets.
8. Lower the vehicle.
9. Remove the compressor manifold and tube assembly.
NOTE: It may be necessary to raise and lower the vehicle multiple times to route the manifold and tube during removal and installation.
INSTALLATION
1. To install, reverse the removal procedure.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil or equivalent.
-
Install new O-rings lubricated in clean PAG oil or equivalent.
2. Evacuate, leak test and charge the refrigerant system.