Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
10. Remove the bolt and remove the bracket.
11. Remove the bolt and remove the bracket.
12. Remove the nut and remove the bracket.
13. Remove the auxiliary line(s).
NOTE: The vehicle may have to be lowered to provide clearance from lift arms.
INSTALLATION
1. To install, reverse the removal procedure.
-
Install new O-rings lubricated in PAG oil or equivalent.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil or equivalent.
2. Evacuate, leak test and charge the refrigerant system.
Aft
REMOVAL
NOTE:
-
The following procedure can be used to remove and install one of, or both, the aft auxiliary evaporator outlet and inlet lines. If only one line is to
be removed and installed, disconnect only the desired line fittings at the specified points within the procedure.
-
Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of
system contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Raise the vehicle.
