Explorer 2WD V8-302 5.0L VIN P SFI (1999)
8. Connect the liftgate handle rod.
1. Position the liftgate handle rod.
2. Close the clip.
NOTE: Make sure the liftgate handle rod is not preloading the liftgate latch remote control. It should be clipped in a relaxed state with no slack.
9. Connect the liftgate latch release rods.
1. Position the liftgate latch release rods by pushing outboard to remove the slack.
2. Close the clips.
NOTE: Make sure the latch release rods are not preloading the liftgate latch remote control. They should be clipped in a relaxed state with no
slack.
10. Install the vent panel.
1. Position the vent panel.
2. Install the pin type retainers.
11. Adjust the liftgate window latch.