Explorer 2WD V8-4.6L (2008)
Cross-Member: Service and Repair
Transmission Support Crossmember
Transmission Support Crossmember
Transmission Support Crossmember
Removal and Installation
1. With the vehicle in NEUTRAL, position it on hoist.
2. Remove the 4 transfer case skid plate bolts and remove the transfer case skid plate.
-
To install, tighten to 15 Nm (11 lb-ft).
3. NOTE: Explorer/Mountaineer shown, Explorer Sport Trac similar.
Remove the heat shield bolt from the RH heat shield.
