Explorer 2WD V8-4.6L (2008)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator and Tube
Removal and Installation
1. Remove the LH exhaust manifold.
2. Remove the oil level indicator and tube bolt.
^
To install, tighten to 10 Nm (89 lb-in).
3. Remove the oil level indicator and tube from the cylinder block.
4. Remove and discard the O-ring seal.
5. NOTE: Install a new oil level indicator tube O-ring seal and lubricate it with clean engine oil prior to installation.
To install, reverse the removal procedure.
