Explorer 2WD V8-4.6L (2008)
Canister Purge Control Valve: Service and Repair
EVAPORATIVE EMISSION CANISTER PURGE VALVE
Removal and Installation
WARNING:
-
When working on or near the evaporative emission (EVAP) system, disconnect the battery ground cable from the battery. The EVAP
system contains fuel vapor and condensed fuel vapor, so an electrical spark may cause a fire or explosion. Failure to follow this
instruction may result in serious personal injury.
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Disconnect the evaporative emission (EVAP) canister purge valve electrical connector.
4. Disconnect the 2 vapor tube quick connect couplings from the EVAP canister purge valve.
5. Detach the EVAP canister purge valve from the bracket and remove.
6. To install, reverse the removal procedure.
7. Leak test the EVAP system. See: Testing and Inspection
8. Carry out the evaporative emission repair verification drive cycle.
