Explorer 2WD V8-4.6L (2008)
Air Bag: Service and Repair
Driver Air Bag Module
DRIVER AIR BAG MODULE
Removal and Installation
WARNING:
-
Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
-
Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the body. Do
not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may
result in serious personal injury in the event of an accidental deployment.
-
Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Remove the 2 driver air bag module bolts.
-
To install, tighten to 7 Nm (62 lb-in).
3. CAUTION: The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module.
Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air
bag module. Damage to the connector or component may occur.
