Explorer 2WD V8-4.6L (2008)
3. Index-mark the driveshaft flange to the pinion flange to maintain driveshaft balance.
4. Remove and discard the 4 driveshaft pinion flange bolts.
^
To install, tighten the new bolts to 112 Nm (83 lb-ft).
5. NOTE: The driveshaft flange yoke fits tightly on the pinion flange pilot. Never hammer on the driveshaft, or any of its components, to disconnect
the driveshaft flange from the pinion flange.
Using a suitable tool, pry only in the area shown to separate the driveshaft flange yoke from the pinion flange and remove the driveshaft from the
extension housing.