Explorer 2WD V8-4.6L VIN 8 (2006)
Rear Door Latch: Service and Repair
Rear Door Latch
REAR DOOR LATCH
Removal and Installation
1. Remove the rear door trim panel.
2. Position the watershield aside.
3. Release the interior door handle actuating cable locator from the door frame.
4. Open the clip and disconnect the exterior handle actuating rod.
5. Disconnect the rear door ajar switch and rear door lock actuator electrical connectors.
6. Remove the 3 rear door latch screws.
-
To install, tighten to 12 Nm (9 lb-ft).
7. Release the rear door push button rod from the door frame retainer.
8. To install, reverse the removal procedure.
-
Lubricate the door latch after installation.