Explorer 2WD V8-4.6L VIN 8 (2006)
20. Remove the lower air duct.
21. Disconnect the electrical connector located at the C-pillar.
-
Release the wiring harness pin-type retainers.
22. Disconnect all of the electrical connectors.
23. Remove the rear pin-type retainer.
24. Disconnect the electrical connector and the wiring pin-type retainers on the A-pillar.
25. CAUTION: To prevent bending or damaging the headliner, an assistant is required to support the headliner while carrying out the
remaining steps.
Open the sun visor center retainer cover and remove the screw.