Explorer 2WD V8-4.6L VIN 8 (2006)
4. NOTE: Note the position and the routing of the OCS sensor wiring, connector and wiring retainers for installation.
Detach the 2 OCS wiring retainers at each OCS rail. Then using a suitable tool, release the tab and disconnect the RH and LH OCS rail electrical
connectors.
All seats
5. Remove the cushion side shield.
1
If equipped, remove the clip and manual recline handle.
2
If equipped, pull and remove the manual lumbar control knob.
3
Remove the scrivet.
4
Release the cushion side shield front clip.
5
From under the cushion side shield, release the 3 hook retainers.
6
Pull out on the cushion side shield at the back and release the pin-type retainer.
-
If equipped with a manual seat track, remove the cushion side shield.
7
If equipped with power seats, remove the seat control switch knob and separate the seat control switch from the cushion side shield.
-
Remove the cushion side shield.
Power seat
6. Separate the seat control switch wire harness pin-type retainer from the cushion frame.
Driver seat
7. Disconnect the SRS seat position sensor.
8. Driver seat with 10-way power, disconnect the backrest power feed electrical connector and route out the wire harness.
-
Release any wire harness retainers.