Explorer 2WD V8-4.6L VIN 8 (2006)
2. Remove the pin-type retainer and the driver side floor console finish panel.
3. Remove the 2 bolts, 2 nuts and the LH instrument panel brace.
^
To install, tighten to 9 Nm (80 inch lbs.).
4. Remove the 2 screws and LH heater duct.
5. Disconnect the stability control sensor cluster electrical connector.
6. Remove the stability control sensor cluster electrical harness retainers and position aside.
7. Remove the 2 stability control sensor cluster bracket nuts and the stability control sensor cluster.
^
To install, tighten to 7 Nm (62 inch lbs.).
8. To install, reverse the removal procedure.